Ríng Sízíng

Please peruse through these simple guides for help determining your ring size ~ with further tips listed below the conversion chart....



Please enter your details below or email studio@cosmicartifact.com with your postage information and I will send you a re-usable ring sizer free of charge :))



Have a moment and feel like an adventure ~ ? Pass by your local jeweller to have your finger/s sized... This is the most accurate method to determine your ring size. It's casual, and usually free....



Step 1 ~ Select a ring that properly fits your intended finger.

Step 2 ~ With a pencil, trace around the inside of the ring onto a piece of paper, keeping the lead closest to the inside edge of the ring.

Step 3 ~ With a ruler, measure the inside diameter. Match this measurement in the conversion table below and note down your size.


D~I~Y ~ !

Step 1 ~ Cut a strip of paper long enough to overlap around your finger. Make sure the width is the same as the ring you have in mind.

You can find the band width measurement underlined in each ring description.

For example, for a ring with a "band width 0.9cm" ~ cut a strip with a width of 0.9cm, and a length that will overlap around your finger.

Step 2 ~ Wrap the paper around the base of your finger, where you would like to wear the ring.  Make sure it is comfortable, and can be taken on and off with ease.

Step 3 ~ Mark the paper where it overlaps/completes the circle.

Step 4 ~ That was awkward, hey! All good, you're pretty much done...

Step 5 ~ Lay the strip out flat and measure the length to the mark.

Step 6 ~ This measurement is the inside circumference. You can now match your measurement in the conversion table below and note down your size. 






Some things to remember...

~ Your left and right hands may be different sizes, so be sure to measure the finger the ring will be worn on most.
~ Your ring should fit your finger comfortably ~ snug enough so it will not fall off, but loose enough to slide over your knuckle.
~ Your finger size changes depending on the time of the day and the weather. For best results, measure your finger at the end of the day when your fingers are warm. 
~ A wide vs. a thin ring band will slightly differ in size ~ please follow the underlined band width in the description of each piece.
~ Measure your finger 3 to 4 times to be as accurate as possible.
~ When using the guides above ~ if your measurement falls between two sizes, order the larger size.


Please note that all Cosmic Artifact ring sizes are listed in US sizing. Please make sure your size is correct before placing an order. If your size is not listed on the product page, please be in touch below and I'll see what I can do.

Unfortunately pieces cannot be exchanged for alternative sizes, as each piece is made-to-order ~ although if you receive your piece and need it re-sized, I am happy to re-size for a small fee.

*Please be in touch below if you should need any further assistance*